 Finishing
| After the axle receives a status indicator, it is shipped to an axle finish shop where it is placed in a roughening lathe. The finishing lathe makes a second cut leaving room for the grinding operation. Axle faces are conditioned to remove roughing processing marks and the axles are drilled and tapped with three bolt holes in the axle ends used to secure the journal bearings. |
|
|
Complete Capabilities For All Axles |
 |
Complete Capabilities
Whether you need your axles rough forged or rough machined, finished or in mounted sets, Standard Forged Products, LLC can meet all your axle needs.
|
|
 |
|
 |
Rough Turning
| The axle is milled to length and a journal collar and center hole are applied. An ultrasonic inspection is conducted to insure internal axle quality. The axle is stamped with ID numbers and is sent to on of three separate rough turn lines. After rough turning, all axles are 100% dimensionally inspected. |
|
|
Grinding
| During the grinding operation, the grinder finishes to a tolerance plus or minus one half thousandths of an inch. The grinder operator will check for size with a temperature compensating micrometer. After grinding, the axle goes to a mandatory hold point. It is 100% inspected. |
|
|
|
|
|
For additional information or to place an inquiry please contact us.
michael.waters@trin.net
Address:
75 Nichol Avenue
McKees Rocks, PA
15136
Phone: 412-778-2033
|
